Type: I-Tec Solar PV Panel Mounting for Flat Roof 8 Degree incl. Screws and 2 Brackets for Standard PV Panel Width: 980-1150mm NEW
You will need at least 2 of these mounts to install 1 PV panel
Compatible with the following PV panels
- Length: approximately 1500 to 1800 mm
- Width: 980 to 1150 mm
- Module Frame Height: 30-40 mm
- Orientation: Cross-Mounting
- Tilt Angle: 8 Degrees
This innovative product demonstrates its advantages through easy installation and minimal roof load. Significant time savings during installation make this product much more cost-effective compared to conventional flat roof systems.
Product Features:
• Universally adaptable
• Easy installation with hook locking
• Can be pre-assembled
• Excellent ventilation
• Fully recyclable
• Weather-resistant
• Low roof surface pressure
• Low roof load
• Drill holes and elongated holes available
• Stackable
• Low weight
• Patented design
Application Area:
This product is intended for the installation of photovoltaic modules on flat roofs. The product may only be used according to this application description. The
expertise of the installation personnel is required. Failure to comply can result in significant hazards, including personal and property damage.
Technical Data:
Area of Application: Flat Roofs
Roof Covering: Foil or Bitumen Roof
Roof Pitch: 0-5°
System Orientation: 8° East-West, Roof Orientation Flexible According to Planning
Module Mounting: Modules with Frames, Horizontal Mounting (Cross-Mounting)
Module Fastening: Frame Clamping on the Rib Back Top and Bottom (Equivalent to the Usual Frame Clamping)
Requirements for Fastening: Usable Rib on the Back of the Frame 10-30mm 1-2.3mm Thickness
Module Dimensions: Width: 980-1150mm - Length: 1500-1800mm (Usable Rib on the Back of the Frame 10-30mm)
Ballasting Material: Recommendation Paver Stones 20x10x8 (approx. 3.7kg) or Material Meeting Comparable Criteria, According to Calculation Table i-tec
Weight: 3.4kg
Material: Aluminum
Fastening Material: Stainless Steel A2
Basic Statics: Certification by External Structural Engineering Office According to Eurocode, DIN EN 1991 1-4, Wind Expertise According to Eurocode Including Wind Tunnel Tests
Country of Origin: Developed and Manufactured in Germany
User Manuals PDF
PDF
